Shandong Mengjite International Trading Co., Ltd.
Tel: +86 0536-2332263
Address: Innovation building, No.2569, Renmin Avenue, Gaomi, Shandong.
Our standard for anti-smashing shoes was formulated from the beginning of the 1990s. In 2007, the old standards of production and testing were revised and new standards were formulated to protect the occupational health and safety of workers.
Anti-smashing shoes in our country can be roughly divided into: to protect the toe smashing shoes (that is, anti-smashing shoes, anti-smashing smashing shoes), anti-piercing smashing shoes (we usually also called anti-piercing smashing shoes), electricity Insulated shoes (that is, we usually referred to as insulated shoes), anti-static anti-smashing shoes, acid and alkali.
Electrical insulation shoes standard GB12011-2009, mainly used for electricians, electronic operators, cable installers, substation installation and so on. This kind of shoes can only be worn in the operating environment below the power frequency voltage 1KV, and the upper must be kept dry, can not touch the sharp, high temperature and any corrosive substances, if the bottom of the corroded or damaged can not be used, Immediately replace the new electric insulating shoes. The company is located in:
Protect the toe anti-smashing shoes standard: GB21148-2007 / GB21147-2007 / GB21146-2007. Inner Baotou safety performance is divided into three levels of safety, protection, occupation, the most commonly used business is safe and protective, it is commonly used in metallurgy, mining, forestry, ports, handling, quarrying, machinery, construction, oil , Chemical industry and so on. The company is located in:
Anti-piercing anti-smashing shoes standard GB21148-2007, the standard requires anti-piercing strength greater than or equal to 1100N can be qualified products for mining, fire protection, construction, forestry, cold work, machinery industry. The company is located in:
Anti-static anti-smashing shoes Standard: GB21148-2007, anti-static shoes In some chemical plants, gas stations, liquefied gas filling and other industries wear more, because these industries are flammable places. Wear anti-static shoes to eliminate the accumulation of static electricity, the insulation resistance is maintained at between 100KΩ-1000MΩ, but when wearing this shoes can not wear thick wool insulation stockings or use insulating insoles, and antistatic clothing to be worn; should wear 200 Shoe resistance test within hours, only the resistance within the specified range can be used as anti-static shoes, or can not wear insulated shoes. The company is located in:
Acid-base anti-smashing shoes Executive Standard is GB12018-1989, the shoes used in electroplating, pickling, electrolysis, with liquid, chemical control and other fields, but requires these areas acid-base concentration can not be too high; the shoes can not touch the high temperature , Can not be sharps injuries, soles can not see leakage, wear immediately after rinse with water, can not be directly exposed to the sun or drying. The company is located in:
Conductive shoes implementation of the standard is GB21148-2007, the shoes have good conductivity, can eliminate the body in a short time the accumulation of static electricity, insulation resistance requirements of less than 100 KΩ, is generally used for highly anti-static or particularly flammable and explosive places, but These places require no risk of electric shock. Conductive shoes and anti-static anti-smashing shoes can not wear the same thick wool insulation stockings or insulation insole, and supporting the use of conductive clothing, but also within 200 hours of resistance test, only qualified to use test.